Futaba 6K V3, R3008SB receiver (mode 1)

Eight-channel Futaba RC kit using the T-FHSS Air-2.4GHz telemetry transmission system for recreational and sports modelers. The transmitter can also be switched to S-FHSS transmission mode and thus use the entire range of S-FHSS receivers (without telemetry) from the miniature six-channel R2106GF to the eight-channel R2008SB. With the R3008SB receiver included in the kit, you have 8 PWM channels for classic servos or 8 channels via the S.BUS and S.BUS2 buses and telemetry data on the receiver's supply voltage and the signal strength captured by the receiver. You can obtain additional telemetry data from additional telemetry sensors connected to the S.BUS2 bus.

The T6K V3S transmitter in a cabinet that fits perfectly in the hand is equipped with precise cross controls with adjustable lock/neutral, 4 switches, 4 digital trims and a rotary proportional control. Three buttons and a multipurpose joystick are used for programming; the backlit LCD display ensures easy orientation in the intuitive menu. The T6K V3S has a memory for 30 models and a wide range of mixing functions for aerobatic aircraft, gliders, helicopters and multicopters. In addition to displaying telemetry data on the display, a voice output of telemetry is available in the socket for the handset (not included in the kit). The T6K is also equipped with a teacher-student socket and also allows programming and setting of S.BUS servos.

To put the transmitter into operation, you will need 4 AA alkaline batteries or NiMH accumulators stored in the holder supplied with the transmitter, or 4-5 cell NiMH or 2S LiFe battery pack.

FUNCTION

• Transmission system T-FHSS Air-2.4GHz with telemetry, S-FHSS 2.4GHz without telemetry
• 8 proportional channels
• Precise cross controllers (transmitters come in Mode 1 or 2, easy to retrofit, also easy to cancel throttle lock completely and have cross controllers neutralized in all axes for drones or tanks)
• Rotary proportional controller, 4 three-position switches, 4 digital trims
• Assignable mix switches, freely assignable controls for channels 5-8
• Programs for aerobatic model airplanes, gliders, helicopters and multicopters
• Updateable software (requires CIU-3 USB interface)
• Socket for programming S.BUS serv
• Multi-purpose joystick and three buttons for easy programming
• Telemetry voice output on headphone jack (3.5mm jack)
• Vibration signaling
• Backlit LCD display 128x64 pixels
• Memory for 30 models
• Gas extinguishing function
• Servo tester and servo monitor with graphic representation of servo deviations
• Resetting model data
• Copying models
• Fail safe emergency deflections
• Trim step setting/trim reset
• Subtrims
• Reversing the direction of servo deflections
• Teacher-student
• Two timers (stopwatch or timer) triggered by switch or throttle

Program menu for aerobatic aircraft

• Setting the size and direction of deviations, double and exponential deviations
• 4 freely programmable mixes (3 linear, one with a 5-point curve)
• Flaperons with adjustable differentiation
• Differentiation of aileron deflections
• Gyro gain control
• 5 point throttle curve
• Engine shutdown
• Safe idle
• Elevon
• Butterfly tail surfaces
• Aerodynamic brake
• Mix elevator-flaps
• Flap-elevator mix

Program menu for gliders

• 6 wing types (1-2 ailerons, 1-4 flaps), 2 types of tail surfaces
• Setting the size and direction of deviations, double and exponential deviations
• 4 freely programmable mixes (3 linear, one with a 5-point curve)
• 4 flight modes
• Flaperons
• Differentiation of aileron deflections
• Butterfly mix
• Mix camber (curvature of the trailing edge)
• Mix elevator-camber
• Mix Motor (motor control by switch with adjustable start and stop)
• Gyro gain control
• Aileron-flaps mix
• Trim mix

Program menu for helicopters

• 6 types of cycle board
• Setting the size and direction of deviations, double and exponential deviations
• 4 freely programmable mixes
• 4 flight modes with adjustable delay
• 5-point throttle curves
• 5-point curves of the collective
• Autorotation
• Gyro gain control
• Revomix
• Throttle delay
• Governor
• Adjustment of deviations and corrections for the cyclic plate

Program menu for multicopters

• Setting the size and direction of deviations, double and exponential deviations
• 6 freely programmable mixes
• 5 point throttle curve
• Gyro gain control
• Throttle position signaling
• Throttle delay

Compatible telemetry sensors

• Temperature sensor (SBS-01T)
• Temperature sensor (SBS-01TE)
• Tachometer with optical sensor (SBS-01RO)
• Tachometer with magnetic sensor (SBS-01RM)
• Tachometer for AC motors (SBS-01RB)
• Voltage Sensor (SBS-01V)
• Current Sensor (SBS-01C)
• Barometric Altimeter/Variometer (SBS-01A, SBS-02A)

RC KIT INCLUDES

• Futaba T6K V3S 2.4GHz transmitter
• Receiver R3008SB
• Switch with charging cable
• Plastic screwdriver
• Operating Instructions