Express delivery
Large selection of carriers
Satisfaction guarantee
Telemetric sensor servo S.BUS2 for RC sets Futaba with telemetric transmission systems FASSTest and T-FHSS Air (for aircraft). It allows measuring the position of the servo lever, current (up to 10A) and temperature (-10 to 115 ° C) of two S.BUS2 servos. Ideal for measuring servo loads during operation and similar applications. The operating states of the sensor are indicated by an LED diode.
Compatible receivers: Futaba receivers with S.BUS2 port
Connection to the receiver: S.BUS2 socket.
Number of addresses required by the sensor: 6 *
Default address number setting (start address): 16 *
Transmitted telemetry data: position of servo lever 1 and servo 2, current taken by servos 1 and 2, temperature of servos 1 and 2
Typical installation: between receiver (S.BUS2 port) and servo 1 and 2; if simultaneous measurement of multiple servos is required, you can use multiple SBS-01S sensors (max. 4 if no other sensors are connected).
Power supply 3.7-7.4V (nominal battery voltage).
Sensor set includes: Sensor SBS-01S with cables, instructions.
*) Telemetry sensors are identified on the S.BUS2 serial bus by an address number ("slot"); more complex sensors transmitting more than one data may require several consecutive addresses - in which case the first address belonging to a given sensor is called the start address.
| Power supply | 3.5-8.4 V |
| Range of measured current | 0-10 A |
| Measured temperature range | -10 to + 115 ° C |
| Length (with cables) | 300 mm |
| Mass | 9.6 g |
