Limit Pro 1.7m ARF orange

Recommended drive

The manufacturer recommends a powerful AC motor for Hotliners, with a diameter of up to 38 mm. A 38mm aluminum propeller cone, a carbon tilting propeller and, depending on the engine, a suitable regulator with a brake are recommended.

Composite construction

The wing and elevator are composite, made in molds, including surface treatment. The surface is therefore completely smooth. The hull is laminate with longitudinal reinforcements of carbon roving.

Elevator in T arrangement

The elevator is attached to the rudder with two screws. The servo that controls the elevator rudder is installed inside the rudder.

One-piece wing

To achieve maximum strength, the composite wing is one-piece and 3 screws are attached to the fuselage.

Recommended transmitters Spectrum of the new generation of the NX series

We recommend modern SPEKTRUM NX programmable transmitters for controlling aircraft models:

• 6-channel transmitter series NX Spectrum NX6 DSMX, AR6610T with Smart compatibility, USB and WiFi connection .
• 8-channel transmitter series NX Spectrum NX8 DSMX, AR8020T with voice output, Smart Technology compatibility, USB port and WiFi connection .
• NX Spektrum NX10 DSMX series 10-channel transmitter with the latest trends, voice output, Smart Technology compatibility, USB port and WiFi connectivity .

Recommended chargers for conventional and Smart batteries

If you decide to use modern Smart LiPo batteries in RC aircraft models, then we recommend the following chargers:

• Charger with mains power supply Spektrum S1100AC with one output 1x100W .
• Charger with mains power supply Spektrum S2100 with two outputs 2x 100W .

Recommended modern chargers for Smart batteries

• High-performance AC charger Spektrum Smart G2 charger S1400 1x400W AC with one output 400W .
• High performance AC charger Spektrum Smart G2 charger S2200 2x200W AC with two outputs 2x200W .

There is a reduction for charging IC5 / IC3 Spectrum conversion cable IC5 device - IC3 battery 10cm 10 AWG.

Accessories for normal operation

For normal operation of flying RC models, you need suitable adhesives, a set of tools and a case for storing LiPol batteries. From our range we recommend a quality set of Allen screwdrivers 1.5 / 2.0 / 2.5 / 3.0mm and Modelcraft Phillips screwdrivers (set of 6). The Modelcraft mini pliers in a case (set) and a Modelcraft cutting knife with an A6 washer will certainly be suitable for assembly.

For quick repair of aircraft models, we recommend the fast-curing 4-minute Epoxy adhesive. From our offer we recommend Speed Epoxy 4 min. 71g

Protective covers for batteries

Protective covers are designed to reduce the risk associated with transporting and charging batteries. LiPo batteries can, while maintaining small dimensions and low weight, provide high discharge currents and have a large capacity. The LiPo battery is prone to mechanical damage and therefore needs to be thoroughly protected.