Traxxas TRX-4 Land Rover Defender 1:10 RTR sand
Express delivery
Large selection of carriers
Satisfaction guarantee
Package contents
The package contains a completely assembled RC model car Traxxas TRX-4 Land Rover Defender, with installed components: DC regulator XL5 HV, DC motor Titan 550 21T 14V, servo 2075X high-torque MG waterproof, 3x servo 2065, receiver TQi 5 channels. TSM, telemetry. 4 channel TQi transmitter. BlueTooth Ready without Bluetooth module installed, tool kit. Instructions CZ and manual EN, DE, FR, SP.
Characteristics
Traxxas has prepared a wonderful novelty for 2017 - RC model of the Traxxas TRX-4 expedition car with a licensed Jaguar Land Rover Defender body!
The model is literally loaded with conveniences - remotely controlled differential locks, two-speed transmission, gantry axles, axle transmission, functional fenders, very detailed processing. Waterproof * electronics and quality design, as you are used to from Traxxas, are a matter of course
TRX-4 chassis
The chassis is built of two steel profiles, which ensure sufficient rigidity of the chassis. Thanks to the engine located in the front part, a sufficient load on the front wheels is ensured, so that the model can easily drive even on steep slopes. The battery is located in the axis of the chassis, so the model is precisely balanced and does not tilt while driving.
To reduce maintenance, the lower part of the chassis is fitted with covers which, together with the fenders (which are part of the body), prevent excessive dirt from entering the model's chassis.
Axles with axle gearbox
The TRX-4 chassis uses gantry axles with an axle gearbox. The axle transmission increases ground clearance, reduces stress on differentials, transmissions, cardan shafts and further reduces torsional force - the model tilts less.
The front wheels can be turned by an angle of 45 °, the steering is provided by a Traxxas 2075X servo with metal gears. Thanks to the new chassis, the model achieved a great approach angle.
Two-speed transmission
The model is equipped with a two-speed transmission. The gear change is controlled by a red rocker switch on the transmitter. This solution makes the TRX-4 a very versatile model that can drive slowly and quickly - as you need .
Lockable differentials
The differential locks are independently controlled by 2 servos. Power from the servos is transmitted via cables to the differentials. The shutters are controlled by a three-position switch on the transmitter and provide the following combinations:
- Both differentials are open
- Only the front differential is closed
- Both differentials are closed
GTS oil dampers
Four oil-filled GTS shock absorbers provide smooth damping and perfect driving characteristics. The aluminum bodies of the shock absorbers are equipped with a nut for adjusting the spring preload. Special sealing X-rings ensure maximum tightness of the damper around the piston rod.
Detailed processing
Great emphasis was placed on detailed processing - as usual, the model is officially licensed by Jaguar Land Rover. In addition to the detailed body with accessories, the model has functional fenders, detailed wheel suspension. LED lighting can be added as an optional accessory.
Power steering
The model is controlled by a digital servo Traxxas 2075X high-torque, with a torque of 9 kg.cm. The servo is equipped with two ball bearings on the square shaft and metal gears for maximum durability. Waterproof * construction.
Transmission and differential servos
The model is equipped with a total of three waterproof * micro servos 2065 with a torque of 2.5 kg.cm. Two servos independently control the front and rear differential locks. The third servo then shifts the two-speed transmission.
Titan 21T engine
The model is powered by a Titan 21T 550 DC motor. The motor provides smooth running from low revs. For better cooling, a propeller blowing air to the rotor is integrated in the motor.
DC regulator
The heart of the Traxxas model is the XL-5 HV DC electronic controller. The controller is designed to be powered by a 2-cell or 3-cell LiPo battery. The model can also be powered by 6-7-cell NiMH batteries. Easy selection of driving modes and other settings, using the EZ-SET button. Indicator status indication by LED diode. LVD protection against LiPo battery undercharge. Thermal protection. Water-resistant * construction.
The Traxxas XL-5 HV controller supports 5 driving modes:
- Sport : Driving forward, brake and reverse
- Race : Forward and brake. Reverse is not available
- Training : Forward travel limited to 50% power, brake 100% and reverse limited to 50%. this mode is suitable for children
- Trail : Forward, brake, reverse. The controls near neutral are very fine
- Crawl : Drive forward, brake in neutral and straight reverse.
Four-channel RC set Traxxas TQi with Bluetooth
In addition to precise and reliable control, the four-channel transmitter is also equipped with a slot for placing a Bluetooth module (sold separately). The Bluetooth module allows you to connect the RC model with the clear graphic application Traxxas Link, which you can install on your Smartphone free of charge.
The Traxxas Link app for Apple devices is available for free on the AppStore , and the Google Android app is free on GooglePlay .
Traxxas Link App is a powerful application that gives you complete control over the operation and tuning of the RC model Traxxas with stunning visualization and absolute accuracy of settings. Traxxas Link can display telemetry data that provides the model in real time, such as speed, rpm, temperature, battery voltage and model tilt. You can share RC model settings, you can create any number of profiles for a specific track or user, eg children. Everything in an application with brilliant graphics, which is a matter of course from Traxxas.
Telemetry options vary by model. It may be necessary to install telemetry sensors to obtain telemetry data. You will find compatible telemetry parts with this model in the "Accessories - Telemetry" section. More information about telemetry installation here.
Telemetry - model tilt
Using the wireless Bluetooth module (sold separately) and the Traxxas link app, it is possible to monitor the tilt of the model on your phone. To display additional telemetry (battery voltage, speed, temperature) it is necessary to install telemetry sensors.
Traxxas TQi receiver
RC receiver Traxxas TQi 5 channels. TSM with telemetry for Traxxas TQi transmitters. Easy operation, pairing with a button. LED status indication. 3-axis MEMS sensors are integrated in the receiver to learn the position of the receiver.
The 5-channel receiver is also equipped with two connectors for connecting RPM (speed) and I / O (voltage / temperature) telemetry sensors.
Furthermore, an expansion telemetry module can be connected to the 4-pin connector, to which you can connect up to 6 other sensors, including a very accurate GPS speed sensor.
Features of the RC model car Traxxas TRX-4 Land Rover Defender 1:10
- The model is completely assembled and ready to ride
- Licensed detailed body model Land Rover Defender
- Differential lock remote control
- Remote controlled two-speed transmission
- Portal axles with gearbox
- Powerful DC motor Traxxas Titan 21T
- Traxxas XL-5 HV DC electronic controller with special Trial and Crawl modes and children's mode. The controller supports LiPo and NiMH batteries.
- High clear height - 80 mm
- 45 ° turn of the front wheels on both sides
- Optimized geometry to limit the bump-steer effect (change in wheel toe depending on ground clearance)
- Tires for excellent grip on the surface
- Long driving time - with LiPo battery 11.1 V 5000 mA up to 2 hours
* For information on water resistance specifications, refer to the operating instructions. Tips and tricks for operating in a wet environment can be found in the blog.
We recommend buying
To put the model into operation, 4x AA batteries for the transmitter, a drive battery and a charger for the drive battery are required.
Recommended LiPo batteries
The model can be operated on a 2 or 3 cell LiPo battery. A 2-cell LiPo battery (7.4 V) is fully sufficient for normal riding. A 3-cell LiPo battery can be used for operation with a higher speed range.
- For normal riding 2S LiPo battery Traxxas 7.4 V 5000 mAh
- For normal driving and maximum driving time 2S LiPo battery Traxxas 7.4 V 7600 mAh
- For demanding users and high speed range 3S LiPo battery Traxxas 11.1 V 4000 mAh
Recommended NiMH batteries
NiMH batteries are not difficult to handle and are therefore suitable if the RC model car is operated by children (NiMH batteries will not be destroyed by complete discharge). However, NiMH batteries have a lower capacity and higher weight, so driving time will be slightly shorter.
- For normal riding NiMH battery 8.4 V 3000 mAh
- For maximum driving time NiMH battery 8.4 V 5000 mAh
Recommended Traxxas chargers
Traxxas universal chargers can be used to charge Traxxas LiPo and NiMH batteries. Traxxas chargers are an easy and safe way to charge batteries. Traxxas uses a unique iD system , thanks to which you are always sure that you will connect everything simply and safely. There is an integrated chip in the battery connector, which the Traxxas charger automatically recognizes and sets all battery charging parameters for you. More information here.
Universal chargers for batteries up to 3S LiPo
- Traxxas EZ-Peak 50W charger with one output
- Traxxas EZ-Peak 2x50W charger with 2 outputs
Universal chargers for batteries up to 4S LiPo
- Traxxas EZ-Peak 75W charger with one output
- Traxxas EZ-Peak Live 100W charger with one output and the possibility of BlueTooth connection to the phone
- Traxxas EZ-Peak Live 2x100W charger with 2 outputs and BlueTooth connection to the phone
Wireless connection to the phone
By adding a Bluetooth module to the transmitter, you get the RC model's wireless connection function with the Traxxas Link application, which you can install on your phone free of charge. We recommend a phone holder to attach the phone to the transmitter.
Clear graphic application allows easy setup of the model. You can also view the telemetry provided by the model in the application. Telemetry options for specific models are listed in our Traxxas RC Models Telemetry blog.
Lighting - constant
For a breathtaking appearance on evening adventure trips, we recommend fitting the model with complete, original LED lighting for the TRX-4 Defender. The lighting not only looks great, but also perfectly illuminates the road. All LED lights of this lighting are constantly lit. The kit cannot be upgraded to Pro Scale later.
For Scale lighting - multifunctional
By installing Pro Scale lighting, you get all the realistic functions like on a real car (functional brake and reversing lights, function turn signals and warning lights, adjustable headlight intensity). Possibility of remote control of lighting by phone via Bluetooth module. Lighting installation on the Defender requires a Pro Scale module and a Pro Scale lighting kit.
Winch
The winch is an integral part of every expedition model that will pull you out of any terrain. The original Traxxas reel is precisely designed to scale for TRX models. The winch is controlled by a remote control and develops a pulling force of up to 4.5 kg. To install the winch, it is necessary to add a tuning bumper - (more in the description of the item).
Shipping bag
Carry the RC model comfortably and safely in a Robitronic carrying bag. The bag is airtight and has an elastic edge that can be adjusted to the model. Thanks to the Velcro strap, the model is easy to carry. The synthetic material can be easily cleaned with water or soap suds if required.
Traxx tracks for any terrain
The new Traxx crawler chassis will give your TRX-4 an unusual, dramatic look and you will drive through any terrain. Easy to install, this tuning belt set delivers a virtually unstoppable upgrade in power and traction.
Recommended tuning servo, required when using optional accessories (increasing the weight of the model)
The TRX-4 model is one of the most user-friendly models, often gaining 1-2 kg in weight due to accessories. When increasing the weight of the model, it is necessary to modify the components and use a stronger servo (for example Traxxas servo 2250 24kg.cm MG waterproof or Traxxas servo 2255 29kg.cm BL MG waterproof). A stronger servo must always be connected via the external Traxxas power supply BEC (set).
Accessories for normal operation
For normal operation of the Traxxas RC car, you need screw glue, high-quality tire glue, silicone shock absorber oil and a set of screwdrivers. From our range we recommend an affordable set of tools for cars.
The screw glue drips the thread or the head of the screw, which fixes it and the vibrations caused by driving do not allow the screw connection to loosen. The screw adhesive has a special composition that allows the screw connection to be easily loosened with a reasonable torque without damaging the screw head. Never use ordinary instant glue, it could be impossible to loosen a screw glued in this way at all!
The tire glue adheres the tires to the rim of the disc. It is always necessary that the tire is firmly glued to the wheel rim around the entire circumference! If the tire is not stuck around the entire circumference, it may rupture. The tire adhesive has a special composition that is able to bond materials such as rubber or nylon, and at the same time the adhesive is flexible after hardening. Never use ordinary instant glue - it is not flexible after hardening and cracks in the tire would gradually form around the rims!
Occasionally it is necessary to add silicone oil to the model's shock absorbers. During normal operation, there is only a slight leakage of silicone oil along the shock absorber piston rods. If the damper piston rod surface or seal condition is in poor condition, the oil leak may be large. So-called repair kits are supplied for these cases. In the range of tuning parts, piston rods with an extremely hard TiN (titanium nitride) coating are supplied with all shock absorbers. TiN-coated piston rods are easily recognizable by their golden-green color.