LED programming card
Express delivery
Large selection of carriers
Satisfaction guarantee
Programming card for air controllers Hobbywing FLYFUN and Skywalker used for easy and fast programming of controllers - at home "on the table" as well as the airport. The controller is connected via servocable socket is located at the top of the card. Card Power is provided from BEC power stabilizer Hobbywing controller or current 4-5čl. NiCd or NiMH receiver battery pack attached to the card (if the regulator OPTO). Programming is done with the attached drive motor and battery (even if OPTO controllers).
Hobbywing controllers can be programmed in a model fitted with a propeller - for safety reasons, but it is recommended to remove the propeller programming - To prevent possible accidents at some omission or operator error.
For programming, the four buttons at the bottom card. With their help you select the programming function for adjusting and setting the value signaled by the corresponding LED. Press "OK" to confirm the changes and sent to the controller, the "Reset" button to clear all settings and return all values \u200b\u200bto the factory default settings. Status communication with the controller LED indicates "Connecting".
Controller with BEC: servocable controller disconnect from the receiver and then plug it into an outlet in the upper right corner of the tab labeled "BEC". Connect the drive battery to the controller; LED lights on the card and show you the current set value of each function - and can adjust!
Controller without BEC (OPTO) servocable controller disconnect from the receiver and then plug it into an outlet in the upper right corner of the tab labeled "BEC". Receiver battery (4.8 to 6.0 V) into the socket on the top right corner of the programming card marked "Batt." Connect the drive battery to the controller; LED lights on the card and show you the current set value of each function - and can adjust!
The list of functions and possible values \u200b\u200bcan be found on a label on the card, a detailed description of the functions indicated in the instructions supplied with regulators Hobbywing.
Compatible regulators Hobbywing
- FLYFUN V4 and older
- Skywalker V2 and older
- Regulators of the discontinued lines Guard and the Sword
[V] | 4.8 - 6 |
Length [mm] | 92 |
Width [mm] | 52 |
Height [mm] | 6 |
Weight [g] | 26 |