Balancer for 2-6 art.

Digital balancer / discharger with LCD display for balancing individual cell voltages or discharging lithium rechargeable packs with 2-6 cells in series and a strain gauge for lithium batteries Clan 2-6 and receiver batteries with a voltage of 1.2 to 8.5 V (without regardless of the type of cells).

Balancer

In the role of balancer can work independently (self leveling) or together with any charger for lithium batteries during charge or discharge. Graupner balancer is connected to the service battery charger connector sets and operates independently of the charger (if connected). Displays the current tension on the set of articles and balances the cells voltage level on the article with the lowest voltage. Graupner balancer is equipped with individual drawers 2-6 Art. System sets the appropriate service connector JST-XH (EasyCopter / Align / DualSky), the accessory is supplied with adapter kits with service connector ThunderPower / ThunderFlight / MPX. For other systems, it is necessary to use the appropriate adapter.

Autonomous balancing: battery pack will only connect to the balancing service connector and balancer discharge voltage equal to the articles on the level of the article with the lowest voltage. For security reasons, you can set the minimum voltage balancing act to prevent further discharge has been deeply discharged pack. End equalization is indicated optically on the display.

Balancing charge / discharge: charge / discharge kit is connected through the service connector to the balancer and through the charging cable to the charger. During charging, the balancer continuously balances the individual cells within +/- 0.01 V to the level of the article with the lowest voltage (draws current from cells with higher voltage).

Balancer activity in both modes is indicated on the LCD display constantly are displayed as individual cell voltages, balancer also draws attention to a situation where the voltage difference between the cells is higher than 0.2 V. < / P>

discharger

In the role of dischargers can set end voltage, then Graupner balancer exhausted all the articles on this level.

battery tester

As a tester batteries with Graupner balancer involved in two ways - for measuring the Lithium battery with 2-6 cells in series connects through a service connector to balance or discharge; while the device is powered by a battery measured. For measuring the Rx battery voltage, the test kit plugs into a special socket servokonektory Futaba or UNI (JR / Graupner / Hitec); In that case Graupner balancer requires power from an external source in the 7.4 to 11.1 zapojovaného through dvoukolíkového connector JST (BEC).