Express delivery
Large selection of carriers
Satisfaction guarantee
The specific operating conditions of receiver and transmitter batteries require a special type of LiPo cells - no high current carrying capacity is required, but low self-discharge and resistance to irregular discharge and "long-term stay" in a fully or partially charged state. We are pleased to present a special range of Li-poly batteries optimized for powering transmitters and on-board RC equipment with a load capacity of 5 / 10C and a maximum charging current of 1C.
Do not charge KAVAN Tx / Rx batteries with a current greater than 1C, for normal operation we recommend using currents in the range of 0.5-1C. We recommend using a balancer each time you charge. KAVAN Tx / Rx batteries do not require initial molding, but we recommend that the current does not exceed 0.5C for the first three charging cycles. There is no need to discharge them before charging - for example, you can safely charge 50% discharged batteries.
The set is supplied in the "Tx Pack" version specially designed for powering SANWA MT4 / M11X / M12 / M12S / M12RS and FUTABA T6J / T8FG / T12FG transmitters and the like. It is equipped with power cables with a Futaba connector. The service connector is a standard type of JST-XH system.
The set contains: Battery KAVAN 5 / 10C, instructions.
| Capacity [mAh] | 2800 |
| Voltage [V] | 7.4 |
| Charging current [A] | 1.4 - 2.8 |
| Max. charging current [A] | 2.8 |
| Discharge current [A] | 14 |
| Max. discharge current [A] | 28 |
| Energy [Wh] | 20.7 |
| Length [mm] | 93 |
| Width [mm] | 30 |
| Height [mm] | 16.5 |
| Weight [g] | 88 |
