Futaba S.BUS / S.BUS2 decoder SBD-3

S-BUS cable decoder enabling the connection of one classic servo (analog and digital) or electronic speed controller to the S.BUS or S.BUS2 serial bus, suitable for analog and digital servos with a power supply of 3.7-7.4 V (nominal), operating voltage range 3.5-8.4 V.

Any channel number can be assigned to the SBD-3 output (the default setting is CH3), so that the connected classic servo or controller will respond to the control signal of the given channel. Channel numbers can be assigned to the decoder output using:

• USB programmer CIU-3 or CIU-2 with utility program for PC SBD-Link
• Futaba transmitter enabling setting of S.BUS servo / decoder SBD-1 (output SBD-3 is set in the same way as output Sx1 of decoder SBD-1): T6K, T10J, T12K, T14SG (V4.0 and higher), FX-22 (V4 .0 and higher)

Using the decoder: The SBD-3 input is connected to the receiver's S.BUS or S.BUS2 port (or to a hub connected to the S.BUS port) and a classic servo (analogue and digital) or speed controller is connected to the outputs. It is also possible to connect an S.BUS or S.BUS2 servo; in this case, the S.BUS / S.BUS2 servo will operate as a classic on the channel that is set for the SBD-3 output, not on the channel stored in the servo memory.

The set includes: decoder SBD-3, instructions.