General motor module for 2-6S Gr. HoTT

The main telemetric module for Graupner HoTT receivers and models with a combustion engine or an electric motor.

• 2x temperature and voltage inputs for sensors. Warning threshold value for minimum / maximum voltage and minimum / maximum temperature
• measurement of voltage of individual cells (balance connector) with warning of minimal voltage
• voltage, current and capacity measurements with minimum / maximum voltage, maximum capacity and maximum current
• programmable current limitations
• current measurement with shunt 2x 1 mOhm parallel = 0.5 mOhm
• speed measurement with warning reaching the min / max value
• Fuel Statement with Warning in 25% increments
• the voice alert can be set to: OFF, 5, 10, 15, 20, 25, 30 sec, permanent alert
• Repeated time alert can be set to: standing, 1, 2, 3, 4, 5 minutes, once

Important note when using telemetric modules 33601, 33610, 33611, 33620, S8437:

• Never make any adjustments or adjustments during the model flight so that the model does not get out of control due to your inattention.
• In any case, do not configure the setting and programming of a telemetry model in flight if your model is equipped with two receivers. Program changes can affect the receiver without relayed telemount modules, and this may cause loss of control over the model.
• Always make all programming and settings on the ground and make sure that only the receiver with active telemetry units is powered.

• 2x temperature; optionally from 0 to 120 or 200 ° C and voltage measurement up to 60V DC
• 1 tachometer to 100,000 rpm for a two-blade propeller
• 1x speed / servo input, 1 tachometer input, 1x speed /" servo output for tachometer
• 1x current, voltage and capacity measurement up to 40A (60A per 1s), voltage up to 30V
• 1x individual cell measurements for 2-6s LiPo, LiIo, LiFe)
• 1x receiver power, input and output
• 1x telemetric output for the receiver
• 1x fuel sensor 0% / 25% / 50% / 75% / 100%