Proboat Recoil 2 V2 26" BL RTR Heat Wave

SMART technology

The Recoil 2 V2 boat model set includes a SMART battery and charger, so it's easy to turn on the charger, connect the battery and start charging. Charging starts and stops automatically.

AC regulator Spektrum 100 A

The new lightweight AC governor is designed with the boat auto-turning in mind, therefore allowing quick forward and reverse speed changes to be made, allowing the boat to be turned upside down even in the roughest conditions. It is programmed with an attached transmitter and an auto-reversal button. With a single push of a button, your boat will be flipped back onto the surface of the water.

Spektrum™ 2300Kv AC marine engine

The Spektrum 4335 AC motor installed has a weight on the rotor that is key to turning the boat back when it capsizes. This eliminates overloading of the drive mechanism.

Heatwave and Shreddy color variants

The Recoil 2 V2 RC boat model has a livery that was created and licensed by Heatwave and Shreddy. Go for the classic black and gold look or go for more pops of color with the Shreddy design.

Sophisticated Deep-V Self-Righting hull shape

The hull cover attaches to the hull with 4 aluminum screws to an EVA rubber seal around the edge of the cover to keep water out of the hull. The shape of the hull will make it much easier to roll the hull back in case of an unwanted capsize.

Waterproof servo Pro Boat 5.3 kg

The high torque servo provides more than enough power to steer the boat safely. Water resistance ensures that the servo will remain functional as a result of getting wet.

Aluminum anodized parts

Aluminum rudder with bracket and adjustable aluminum propeller shaft bracket are durable supports for important functional components of the propulsion assembly. Anodizing provides durable protection against oxidation and also contributes to a perfect appearance.

Flexible shaft drive

Flexible adjustment of the inclination of the output shaft, allows adjustment of the engagement angle of the propeller, which allows the model to be used on most water surfaces.

Stainless steel plates

Stabilization and correction surfaces on the stern of the ship's hull made of stainless steel have high strength, durability and resistance to damage. By adjusting the slope of the surfaces, you can adjust the driving characteristics of the ship.

Unrivaled fast cornering

The Recoil 2 hull with rudder system has been precisely tuned to provide high performance and stability. The low center of gravity combined with carefully tuned rudders makes it one of the boats with the smallest turning radius. Don't worry about capsizing because this boat loves fast turns.

Buoyancy foam on the canopy and in the fuselage

If you manage to forget to tighten the screws of the cover, or if you crash the model into an obstacle, there is foam in the hull cover and in the hull itself, which should help keep the parts above the surface.

Practical stand

When you reach your destination and want to change the battery, a practical stand is available in the package. Thanks to the foam strips, you will not damage the bottom of the boat and the model will not slide on the stand.

Recommended LiPol accumulators

To power the RC boat model, we recommend a high-quality LiPol battery (50 C+) with 3 cells in a Hard Case package with a capacity of 5000 mAh/3S.

• 
  
• For regular riding Spektrum Smart LiPo 11.1V 5000mAh 50C HC IC3 with IC3 connector and Smart technology.
  
• For faster driving Spektrum Smart LiPo 11.1V 5000mAh 100C HC IC3 with IC3 connector and Smart technology.
  
  

Spektrum batteries with Smart technology currently represent the most modern and safest way to maintain and charge batteries. The benefits of Spektrum Smart technology can be found here.

Recommended chargers for conventional and Smart batteries

If you decide to use modern Smart LiPo batteries in RC model airplanes, then we recommend the following chargers:

• 
  
• Network charger Spektrum S1100AC with one output 1x 100W .
  
• Network charger Spektrum S1400 with one output 1x 400W .
  
• Network charger Spektrum S2200 with two outputs 2x 200W .
  

Accessories for normal ship operation

For the normal operation of the RC model ship, you need a special grease to lubricate the ship's shafts. The special composition ensures the smooth operation of the shaft in the Teflon tube while maintaining the maximum service life of the components. We recommend Marine grease or Marine grease with grease nipple.

Protective covers for accumulators

Protective packaging is intended to limit the risk associated with the transport and charging of accumulators. LiPo accumulators, while maintaining small dimensions and low weight, can provide high discharge currents and have a large capacity. The LiPo battery is particularly susceptible to mechanical damage and therefore needs to be thoroughly protected.