Mad Flow Brushless V3 2.4GHz RTR

Installed electronics

All electronics components are installed in the hull of the ship. In the front there is a motor, regulator and receiver, on the left side of the battery and on the right side there is a servo.

2.4 GHz RC kit

The model is controlled by a reliable RC kit with 2.4GHz modulation. The transmitter is powered by four AA pencil batteries.

Outboard engine mock-up

The outboard engine is a common accessory of all sports boats and is an integral part of this type. However, it is not functional, it acts as a mock-up element. The propeller drive is led by a shaft from inside the hull.

Attractive coloring

The model has a complete finished color of the racing boat.

Turning the ship

When turning the boat on its back, the boat turns back after a while, thanks to a smart and simple solution. At the stern is an opening into which water flows and the ship turns to the port side. Then just add gas, the boat will start, the water will flow out and you can continue driving.

Recommended chargers for conventional LiPol and Smart batteries

If you decide to use modern Smart LiPo batteries in RC models of airplanes or helicopters, or to charge your batteries from other manufacturers, then we recommend the following chargers:

• Charger with mains power supply Spektrum S150 with one 50W output.
• Charger with mains power supply Spektrum S1100AC with one output 1x100W .
• Charger with mains power supply Spektrum S2100 with two outputs 2x 100W .

Recommended modern powerful chargers for Smart batteries

• High performance AC charger Spectrum Smart G2 charger S1400 1x400W AC with one 400W output.
• High performance AC charger Spektrum Smart G2 charger S2200 2x200W AC with two 2x200W outputs.

There is a reduction for charging IC5 / IC3 Spectrum conversion cable IC5 device - IC3 battery 10cm 10 AWG.

Recommended chargers for conventional LiPo batteries

If you decide to run the model on conventional LiPo batteries , we recommend using universal chargers with a power of at least 50 W. < / p>

Dynamite Prophet Sport charger with two 50 W outputs

Accessories for normal ship operation

For normal operation of a functional RC boat model, you need a special lubricating grease for lubricating the ship's shafts. The special composition ensures the smooth running of the shaft in a Teflon tube while maintaining the maximum service life of the components. DYNE4200 and DYNE4201 greases are recommended

For finishing work or routine maintenance, special tools and instruments from Shesto will come in handy, such as pliers, tweezers, files, screwdrivers and much more, which you can find at www.astramodel.cz/cz/katalog/naradi-c189.html