- -5.04 €
Rocket Brushless V2 2.4GHz RTR
Express delivery
Large selection of carriers
Satisfaction guarantee
Package contents
Finished assembled painted RC model boat Rocket Brushless V2 with installed water-cooled AC motor, 30A water-cooled AC regulator, waterproof servo 9g with MG and receiver 2.4HGz, The package includes a spare propeller, Joysway 2.4GHz FHSS transmitter, stand and manual .
Characteristics
Rocket Brushless V2 2.4GHz RTR high-speed RC boat model. Length more than 60cm, AC water-cooled motor and 30A regulator. RC set Joysway 2.4 GHz FHSS with receiver. Attractive color, plastic hull, Recommended LiPol 3S 2200mAh.
The hull is made of high quality very rigid plastic with an effective surface finish. A 9g servo steering is installed, which controls the aluminum rudder. The drive is a 3 mm flexible shaft with a 2-blade propeller. The model is supplied without a drive battery and charger, a 3-cell LiPol battery 1300 - 2200 mAh 11.1V 35C is recommended. It is also necessary to add 4 alkaline AA batteries to the transmitter.
Features Rocket Brushless V2 2.4GHz
- Alternating water-cooled motor
- AC water-cooled regulator 30A
- 2-channel FHSS RC kit 2.4GHz
- 2-channel 2.4GHz receiver
- Durable ABS hull
- Servo control 9g
Water-cooled regulator 60A
a 30A AC regulator with water cooling is installed in the front part. The water passes through the regulator and the engine, the warm one leaves the boat and is sucked into the circulation cold.
Water-cooled engine
The model is powered by an AC motor with water cooling. The motor has an impeller and the motor is cooled in the middle part with ribs.
Installed electronics
All electronics components are installed in the hull of the ship. In the front there is a motor, regulator and receiver, on the left side of the battery and on the right side there is a servo.
2.4 GHz RC kit
The model is controlled by a reliable RC kit with 2.4GHz modulation. The transmitter is powered by four AA pencil batteries.
Deck cover
A rubber seal is placed on the perimeter of the hull inlet against the ingress of water. The body is pushed with a pin into the hole in the front part and secured with a rotating lock which is on the back of the body.
Turning the ship
When turning the boat on its back, the boat turns back after a while, thanks to a smart and simple solution. At the stern is an opening into which water flows and the ship turns to the port side. Then just add gas, the boat will start, the water will flow out and you can continue driving.
We recommend buying
We recommend purchasing 4x AA batteries for the transmitter, a 3S LiPol battery 1300 - 2200 mAh 11.1V 35C and a suitable charger are recommended.
Recommended chargers for conventional LiPol and Smart batteries
If you decide to use modern Smart LiPo batteries in RC models of airplanes or helicopters, or to charge your batteries from other manufacturers, then we recommend the following chargers:
- Charger with mains power supply Spektrum S150 with one output 50W . <
- Charger with mains power supply Spektrum S1100AC with one output 1x100W .
- Charger with mains power supply Spektrum S2100 with two outputs 2x 100W .
Recommended modern powerful chargers for Smart batteries
- High performance AC charger Spectrum Smart G2 charger S1400 1x400W AC with one 400W output.
- High performance AC charger Spektrum Smart G2 charger S2200 2x200W AC with two 2x200W outputs.
There is a reduction for charging IC5 / IC3 Spectrum conversion cable IC5 device - IC3 battery 10cm 10 AWG.
Recommended chargers for conventional LiPo batteries
If you decide to run the model on conventional LiPo batteries , we recommend using universal chargers with a power of at least 50 W.
Dynamite Prophet Sport charger with two 50 W outputs
Accessories for normal ship operation
For normal operation of a functional RC boat model, you need a special lubricating grease for lubricating the ship's shafts. The special composition ensures the smooth running of the shaft in a Teflon tube while maintaining the maximum service life of the components. DYNE4200 and DYNE4201 greases are recommended
For finishing work or routine maintenance, special tools and instruments from Shesto will come in handy, such as pliers, tweezers, files, screwdrivers and much more, which you can find at www.astramodel.cz/cz/katalog/naradi-c189.html