Tungsten weight for regulator 22g, 35x34x1.0 mm

The Revoltion Design Tungsten Under ESC Weight is a 1.0mm thin tungsten plate that fits under almost any 1/10th scale ESC with dimensions of 35 x 34mm - which exactly matches the basic dimensions of popular units such as the Hobbywing XR10 PRO or RUDDOG RXS. Because tungsten has a density of approximately 19.3g/cm3 - which is more than double the density of brass (? 8.7g/cm3) and much more than steel (? 7.85g/cm3) - the plate provides 22g of weight while remaining half as thin as typical 2mm brass washers and even thinner than many 1.5mm tungsten alternatives. The result is a significantly lower center of gravity and a perfectly placed weight that balances the battery side of the chassis, promoting smoother weight transfer and more predictable control.

The 35 x 34 mm square outline matches the controller housing. Precision-ground edges, a natural matte gray finish, and laser-engraved logos underscore the premium design. Assembly is quick using double-sided tape with a thickness of 0.1-0.2 mm.

FEATURES

• High-density material - tungsten for maximum weight at minimum height
• Thickness of only 1.0 mm: lowers electronics and center of gravity better than brass or thicker tungsten plates
• Dimensions of 35 × 34 mm are suitable for the most common 1/10 controllers (Hobbywing XR10 PRO, RUDDOG RXS, etc.).

TECHNICAL DATA

• Material: Tungsten alloy
• Weight: 22 g ± 1%
• Length × width × thickness: 35 mm × 34 mm × 1.0 mm
• Surface treatment: finely ground, natural tungsten gray