Express delivery
Large selection of carriers
Satisfaction guarantee
RC set Absima CR6S 2.4GHz FHSS
Six-channel RC set
of the lower middle class operating in the 2.4 GHz band. For the 1st and 2nd channel (control and throttle) it is possible to quickly set the reverse deflection, trim and deflection magnitude. For channel 3 and
4, the amount of deviation can be changed programmatically. The third channel is controlled by the button switch
- after pressing the button the function is permanently switched on (it is not necessary to keep the button pressed
permanently), by pressing the button again the function is switched off. The fourth channel is controlled by a
three-position switch with a center / neutral position, ideal for controlling eg a
winch. The fifth channel is controlled by a button, after pressing the servo lever moves from the position
of the left deflection approx. 65% to the deflection 100% (full deflection), after pressing the button
it returns to 65% again. The sixth channel is controlled and works the same as the fifth, only the lever
of the servo moves to the opposite side - to the right. Channels 5 and 6 cannot be controlled by most
electronic switches, they are only suitable for mechanical control of auxiliary functions!
The transmitter is also equipped with a gas and control mix, which is designed to control eg tracked vehicles or boats with two electric motors, where change of direction is controlled by changing
the speed of the electric motors. The transmitter is equipped with a simple program menu,
in which it is possible to set the amount of deflection of channels 3 and 4, and to activate / deactivate
control and throttle mix.
Control of individual channels:
1st channel
- steering wheel, Trim, Reverse and EPA functions available
2nd channel - accelerator / brake, available
Trim, Reverse and EPA functions
3rd channel - pushbutton switch (on / off, full
deviation -100% - + 100%, can be programmatically limited)
4th channel - three-position switch
on-off-on (ideal for controlling eg winch, full deflection -100% - 0% - +100%,
can be programmatically limited)
5th channel - pushbutton switch, deflection only to the right,
limited by the range of approx. 65-100%
Channel 6 - pushbutton switch, deviation only to the left,
limited r range approx. 65-100%
Technical parameters of the Absima CR6S transmitter:
-
2.4GHz FHSS modulation (3ms response time)
- possibility of symmetrical limitation of end
deflection points for channel 1-4
- mechanical trims for gas and control
- setting
the reverse deflection run for channel 1 and 2
- low voltage indication of the transmitter
-
transmitter supply voltage 4.8-12V (possibility of 2-3S LiPo power supply)
- possibility of mix
control and throttle for twin-motor drives
Technical parameters of the receiver
Absima R6WP
- number of channels: 6
- supply voltage 3.3-10V (support for
HV servos)
- current consumption: 30mA
- weight 7g
- dimensions: 35x20x13mm
