GO-1035MG Plus (0.07s/60°, 22kg.cm)

A new version of a powerful and very fast programmable digital low-profile servo with significantly improved parameters. The GO-1035MG Plus has a new brushless motor providing higher thrust and speed, titanium gears (same as the original GO-1035MG) and an output shaft mounted on two ball bearings. It is ideal for use primarily in F3A aerobatic model aircraft, RC jets, hotliners and 3D helicopters of size 400-500. For perfect cooling even under high loads, the servo is housed in an aluminum box.

With the help of the USB programmer/interface for GO servos and the PC operating program, you can program a wide range of servo parameters (dimensions of deflections, sense of deflections neutral, overload protection, soft start, fail-safe, etc.).

Programmable functions

• Deflection Size: Used to set the maximum servo deflection size. The default setting is about 120° at the normal control pulse width range (900~2100 µs); about 180° at the maximum allowable control pulse width range (500~2500 µs).
• Servo Neutral: Used to set the neutral (center) position of the servo.
• Damping: Sets the characteristic of the servo's behavior when stopping its movement.
• Output Power: Sets the servo output power. The higher the value, the faster and more powerful the servo will be – of course, the higher the current draw will be. Range: 39.2~100%
• Sensitivity: Sets the sensitivity (deadband width) of the servo. The higher the value, the narrower the deadband – the servo will only move if the change in the control signal width is greater than the deadband width. Setting the sensitivity value too high can cause servo oscillation in some applications. Range: Ultra High (Extra high – deadband approx. 1 µs) – High (High – approx. 2 µs) – Medium (Medium – approx. 3 µs) – Low (Low – approx. 4 µs)
• Soft Start: Enables/disables the soft start function. This function prevents the servo from suddenly moving to the operating position after powering it on, reducing the risk of damage to its gears.
• Reverse direction of deflections: Reverses the direction of servo deflections.
• FUTABA SR Mode: Only for use with FUTABA RC channels operating in SR mode. Do not enable this option if you are using a different FUTABA RC setup or any other brand of RC.
• SANWA SSR Mode: Only for use with SANWA RC channels operating in SSR mode. Do not enable this option if you are using a different SANWA RC setup or any other brand of RC.
• Fail-safe emergency deflections: In the event of a complete loss of control signal from the receiver or if the servo cannot detect the signal correctly (e.g. due to interference), the servo can go into one of three emergency modes:
  • (a) Free: Fail-safe is disabled.
  • (b) Position hold: the servo holds the position corresponding to the last correctly received signal.
  • (c) Transition to neutral: The servo returns to the neutral (pulse width 1500 µs) position.
• Overload Protection: Enables or disables servo overload protection in three levels – once the overload lasts for a preset time (in seconds), the servo output power is limited to the corresponding preset value (in % of max power).
• Reset: Restores the connected servo to its factory default settings.

Extended supply voltage 4.8-7.4 V (nominal).

Output shaft with 25 teeth/5.92 mm spline.