Express delivery
Large selection of carriers
Satisfaction guarantee
SAVAGE Mini is a high-performance 3D aerobatic special in the park-fly category made of EPP foam designed to be powered by AC electric motors with a power of 200-300 W. A few hours with instant glue in hand are enough to complete this model capable of flying classic F3A setup maneuvers, as well as hanging on a propeller and performing all other 3D tricks. It is also intended for less experienced pilots; with smaller deflections, it can be flown by anyone who already has at least some experience with aerobatics and is able to reliably fly a roll, turn and spin with the previous model. Thanks to the low weight of the model, any accidents due to "hand entanglement" do not hurt too much - and the EPP parts are so easy to repair!
The one-piece wing with large ailerons has a symmetrical profile, carbon beams provide strength and, of course, there are prepared shafts for servos. The fuselage is profiled with a horizontal section thoroughly reinforced with carbon flanges and a vertical section with a large side surface (together with SFG winglets on the wing) for perfect behavior in knife-edge flight. The sophisticated design includes plywood engine mounts anchored to the fuselage using carbon flanges. The fuselage has prepared elevator and rudder servo shafts. The tail surfaces are also made of EPP. The ailerons, rudder and elevator are controlled by short straight carbon rods. The main landing gear is made of carbon with two light wheels and EPP covers; The support plate is anchored to the fuselage with 3D printed plastic brackets and is attached with 4 screws.
To control the model, you will need at least a four-channel RC kit, which should at least have the ability to set double and exponential deflections.
For undemanding recreational flying, common analog microservos with metal gears such as KAVAN GO-13MG, Hitec HS-65MG, etc. are sufficient. If you are serious about aerobatics, you should use strong and fast digital servos with metal gears such as KAVAN GO-1013MG, Hitec HS-5065MG, etc.
For propulsion, we recommend a KAVAN C2830-1300 brushless electric motor, Model Motors AXI 2212/20 V2 or similar with an APC 10x4.7SF propeller powered by a 3S LiPo battery.
The speed controller should have a load capacity of at least 30 A, and especially if you use strong and fast digital servos, it should have a powerful switched-mode power stabilizer BEC such as KAVAN PRO-30SB.
A three-cell LiPo battery 1200–1300 mAh with a load capacity of at least 40C is suitable for power supply.
SAVAGE Mini was designed and manufactured in the Czech Republic.
The kit contains: printed parts of the fuselage, wings, tail surfaces and landing gear covers cut from EPP foam, plywood engine bed, 3D printed plastic parts, carbon reinforcements, levers, forks, rods and other small accessories, carbon chassis with lightweight wheels, detailed picture instructions for building.
Warning
According to Commission Regulation (EU) 2019/945 of 12. March 2019 on unmanned systems and on operators of unmanned systems from third countries and Commission Implementing Regulation (EU) 2019/947 of 24 May 2019 on rules and procedures for the operation of unmanned aircraft operators and pilots of unmanned aerial vehicles (classical model aircraft, multicopters, drones) weighing more than 250 g or carrying a camera or other sensor capable of capturing personal data in any way are required to register (in the Czech Republic with the Civil Aviation Authority). Further information can be found here: Registration of drone operators and pilots
| Span [mm] | 1000 |
| Length [mm] | 1020 |
| Weight [g] | 500 |
| Controlled functions | S,V,K(4),M |
| Construction difficulty | S2 |
| Pilotage difficulty | P2,P3 |
