Express delivery
Large selection of carriers
Satisfaction guarantee
The DC motors of the FOXY Brushed series are perfectly suited for a whole range of modeling applications - for the propulsion of aircraft, ships, cars, tanks and other ground-based and direct-to-gear ground technology.
When installing and connecting FOXY Brushed motors, make sure that you do not exceed the permissible values for supply voltage and current load.
Engine cooling: In operation, the temperature of the outer casing of the engine should not exceed 80 ° C. In the model, therefore, it is always necessary to ensure sufficient access of cooling air and its flow around the engine; in the case of ship models, we recommend using water cooling. High motor loads are only possible for short periods. After each flight / ride, the engine must be allowed to cool to room temperature before taking off / sailing again.
FOXY 700 Race 9.6 V is a DC electric motor size "700" with a shaft with a diameter of 5.0 mm and plain bearings suitable for the propulsion of aircraft models with direct drive (9x4 propellers) or with a gearbox, for car and boat models (propeller 35-40 mm).
To control its speed, you will need an electronic controller with a load capacity of 60-80 A.
FOXY 700 Race 9.6 V is a suitable replacement for the Speed 700 Race 9.6 V engine (cat. No. 6318).
Engine kit includes:| Voltage (rated) [V] | 9.6 |
| Voltage (operating) [V] | 4.8 - 20 |
| Speed at rated voltage [rpm] | 18000 |
| Regulator [A] | 60 - 80 |
| Diameter [mm] | 42.2 |
| Length (cabinets) [mm] | 66 |
| Shaft diameter [mm] | 5 |
| Free shaft length [mm] | 10.5 |
| Weight [g] | 370 |
