Express delivery
Large selection of carriers
Satisfaction guarantee
The DC motors of the FOXY Brushed series are perfectly suited for a whole range of modeling applications - for the propulsion of aircraft, ships, cars, tanks and other ground-based and direct-to-gear ground technology.
When installing and connecting FOXY Brushed motors, make sure that you do not exceed the permissible values for supply voltage and current load.
Engine cooling: In operation, the temperature of the outer casing of the engine should not exceed 80 ° C. In the model, therefore, it is always necessary to ensure sufficient access of cooling air and its flow around the engine; in the case of ship models, we recommend using water cooling. High motor loads are only possible for short periods. After each flight / ride, the engine must be allowed to cool to room temperature before taking off / sailing again.
FOXY 250 7.2 V is a DC electric motor of size "250" with a shaft with a diameter of 2.0 mm and plain bearings suitable for the propulsion of indoor models of aircraft with direct drive (4x3.5 "propellers) or with a gearbox, for small models of cars and ships .
To control its speed, you will need an electronic controller with a load capacity of 6-8 A.
FOXY 250 7.2 V is a suitable replacement for the SPEED 250 7.2 V motor (cat. No. 6374).
Engine kit includes:| Voltage (rated) [V] | 7.2 |
| Voltage (operating) [V] | 3.7 - 7.4 |
| Speed at rated voltage [rpm] | 15000 |
| Regulator [A] | 6 - 8 |
| Diameter [mm] | 20 |
| Length (cabinets) [mm] | 25 |
| Shaft diameter [mm] | 2 |
| Free shaft length [mm] | 8.5 |
| Weight [g] | 22 |
