49" Challenger ARF - green
Express delivery
Large selection of carriers
Satisfaction guarantee
The 1250mm wingspan Challenger sports aerobatic high-wing model is the ideal model for a break from experienced pilots, but equally well suited to recreational flyers, for whom it can be the first fully aerobatic machine.
The hull is a classic "box" construction made of light plywood and balsa covered with Oracover® iron-on film. It is prepared for the installation of a 500-600 W AC electric motor in the rear assembly, such as KAVAN C3542-1000, KAVAN PRO 3542-1150, Model Motors AXI 2820/12, etc. with a 40-60A speed controller with a powerful SBEC power stabilizer. Access to the on-board electronics and propulsion battery compartments is provided by removable covers on the top and bottom of the bow. Micro servos for rudder and elevator control are installed in the tail section of the fuselage.
The two-part wing with a semi-symmetrical profile is also a classic all-balsa construction with an iron-on foil coating; the halves slide from the side onto the carbon tube coupler and secure with screws. The ailerons along the entire span of the wing are controlled by two micro servos mounted in the wing using short wire rods with ball studs.
The tail surfaces are light all-balsa construction with an iron-on foil coating.
The main chassis is made of duralumin with light foam wheels of large diameter, the wire spur is coupled with the turn signal.
You will need at least a four-channel RC kit to control the model, but to use the model's full potential you should use at least a six-channel computerized RC kit allowing independent control and mixing of the ailerons. For rudder control, use good 17g microservos with metal gears, such as KAVAN GO-17MG, Hitec HS-85MG; for 3D wildness, use strong and fast digital micro servos like the KAVAN GO-1020MG.
To drive the model, you can use a 500-600 W AC electric motor, such as the KAVAN PRO 3542-1150 with a 12x6-6.5 propeller, a 50-60A regulator and a 3S LiPo battery 2200-3000 mAh with a load capacity of at least 30C; for really 3D antics, at least 40C.
ARF kit includes: assembled fuselage, wing, iron-on foil coated tail surfaces, carbon wing joint, duralumin main landing gear and spur with light wheels, propeller cone, small accessories, sheet of self-adhesive decals, instructions.
Span [mm] | 1250 |
Length [mm] | 1006 |
Weight [g] | 1170 |
Wing area [dm 2 ] | 27.4 |
Difficulty of construction | S1 |
Difficulty of piloting | P2, P3 |
Controlled functions | S,V,K(2),M |