Yak-11 1450mm ARF Red / White

Yakovlev Yak-11 was a Soviet training aircraft, a two-seater single-engine low-flying aircraft with a stern retractable landing gear powered by a star engine Švecov AŠ-21. 4566 pieces of this aircraft were produced.

The fuselage of the model is made of foam EPP pressed into a negative mold. You will find space for the propulsion battery and receiver under the removable upper part of the fuselage.

The two-part sash with a semi-symmetrical profile connected by a plywood beam is also made of EPP foam. The ailerons and slotted flaps are controlled by short straight rods with two pairs of servos mounted in the wing.

The tail surfaces are made of EPP foam, screws are attached to the fuselage. Servos located in the rear of the fuselage are used to control the rudders, they are connected to the rudders by wire rods.

The chassis is a two-wheel electric retractable with wire legs. the spur wheel is steered, connected to the rudder.

All servos are digital with metal gears of size 12g (Ailerons and flaps) and 19g (Direction indicator and elevator). The equipped motor is an outrunner size BL5052 KV410 with 80A Hobbywing speed regulator and 5V / 8A UBEC. Included is an APC 17 "propeller.

To control the model, you will need at least a six-channel RC kit - if you leave the model in the default version, where both aileron and flap servos and both retractable landing gear are connected to one channel of the receiver. If you want to maintain independent servo control of these functions, you will need at least a nine-channel RC kit.

As a propulsion battery you will need a LiPo six-cell 22.2V 5000mAh with a load capacity of at least 30C. The cable to the controller in the model is equipped with an EC5 connector (PELIKAN DANIEL # 1ME1247P and 1ME1247).

ARF set includes: Fuselage made of foam EPP with installed engine, ESC and servos Vop and Sop, wing made of EPP with installed servos of ailerons, flaps and retractable landing gear, tail surfaces made of EPP, wing coupling, small model accessories, APC propeller 17 ", set screws and instructions / p>