Four-channel RC set Absima CR4S 2.4GHz, 2x receiver

RC set Absima CR4S 2.4GHz AFHDS ANT 2x receiver
Four-channel RC lower middle class set operating in the 2.4 GHz band. For the 1st and 2nd channel (control and throttle) it is possible to quickly set the reverse deflection, trim and deflection magnitude. Channel 3 and 4 can be programmed to change the amount of deviation. The fourth channel is controlled by the button switch - after pressing the button the function is permanently switched on (it is not necessary to keep the button permanently pressed), by pressing the button again the function is switched off. The third channel is controlled by a three-position switch with a center / neutral position, ideal for controlling eg a winch. The transmitter is equipped with a simple program menu in which it is possible to set the size of the deflection of channels 3 and 4. The transmitter is equipped with a mode for beginners, where the power / speed of the model is reduced to 50%. The receiver is equipped with a safety function Failsafe, which in case of loss of the signal from the transmitter sets the servos and the controller to a pre-programmed position (this will prevent accidental passing of the model and a possible accident) .

Control of individual channels:
1st channel - steering wheel, available Trim, Reverse and EPA functions
Channel 2 - accelerator / brake, Trim, Reverse_ and EPA functions available
3rd channel - three-position on-off-on switch (ideal for controlling eg winch, full deflection -100% - 0% - + 100%, can be programmatically limited)
4th channel - pushbutton switch (on / off, full deviation -100% - + 100%, can be programmed )


Technical parameters of the Absima CR4S transmitter:
- 2.4GHz AFHSS ANT modulation with frequency band hopping
- possibility to limit deviation endpoints for all channels
- mechanical trims for gas and control, electronic for channels 3 and 4.
- setting the reverse run of the deflection for channel 1 and 2
- low voltage indication of the transmitter
- transmitter supply voltage 4.8-7.4V (possibility of 2S LiPo supply)
- Beginer mode for beginners, limits power / speed to 50
- safety functions of the Failsafe receiver

Technical parameters Absima R4WP Micro receivers
- frequency 2.4GHz AFHSS ANT
- number of channels: 4
- supply voltage 3.5-8.4V
- weight 5g
- dimensions: 31x18x13mm
- compatible only with Absima CR4S transmitter

Package contains transmitter CR4S, 2x receiver R4WP Micro, manual