Superhero Captain Storm, 305mm rubber

Gumáček balsa with a detachable wing, tail and landing gear. You can build a model by simply plugging into the milled notches and grooves in the hull; for more durability and stability settings can be parts of the model glue glue acetone (Kanagom, L-510, UHU-Hart et al.) or thin glue.

The kit contains: fuselage, wing stamped and printed already formed into a dihedral, předseknuté tail and cabin, wired chassis with wheels, propeller-head harness and rubber (rubber 3x1).

Tip for construction: The tail and cabin are supplied as předseknuté in balsa wood cutting board - parts NEVYLAMUJTE! Breadboard turn the printed side down and lightly sand the fine sandpaper (no. 180 or finer). The parts can then be easily separated; if they still have some wood fibers "tied" to a cutting board, carefully separate the part with a sharp knife (suitable eg. snap-off knife with freshly chipped edge).

Treatment of rubber harness: The new rubber carefully wash it in soapy water and allow to dry. Then, lubricate it with castor oil (sold in pharmacies) or silicone grease to lubricate fishing lines (available in most stores fishing equipment). After flying harness with the model, remove and store it in a sealed plastic bag. Lubricated rubber volume unfolds smoothly and with less friction - provides more power and last longer. The new bundle is also advisable to first fetch - for the first 2-3 years to film only 80-100 rpm, only then can safely shoot more.