Express delivery
Large selection of carriers
Satisfaction guarantee
Thanks to the 2.4 GHz GRAUPNER HoTT technology, the five-channel receiver has a new high-frequency, step, telemetry, transmission unit with state-of-the-art components and the latest software. The receiver voltage and temperature parameters as well as the signal strength are transmitted without additional sensor systems.
With this receiver, it is now possible to operate the multicopter without using external flight control. Thanks to the associated elimination of additional electronics and cables, you can save weight.
Integrated flight control is fully configurable via HoTT telemetry, which greatly simplifies setup. The system sets the control commands very precisely, giving a quickly known flying feeling especially in FPV Racing.
On channel 5, you can switch between two flight modes that allow, depending on your preference, Attitude mode (self-neutralizing situational mode) that limits tilt to approximately 50 degrees, or Rate mode (also called acro mode). allowing overturning and acrobatic elements. There is no angle limitation and can be freely controlled across each axis, just like a helicopter model.
The simple control function makes learning control channels a breeze. When the display is activated, all ESCs are simultaneously operated directly on the throttle.
The automatic roll-over function can be activated via channel 6> 110%. At the next torque or spacing> 50% command, the helicopter will automatically tilt in the specified direction.
Channels 7 and 8> 50% can be used as switching channels. Via FET eg LEDs or DIP switch of FPV transmitter can be connected.
When the display is activated, all ESCs simultaneously operate and teach the throttle lever directly.
Maximum power and stability is achieved by adjusting the ratio of rotation sensitivity to sensitivity to Nick on unbalanced multicopters. Similarly, the Gyro-limit can be infinitely adjusted to achieve high sensitivity but with strong drives. < The following multicopter types are supported:
Quadro X, Quadro +, Hexa V, Hexa I, Tri L, Tri R
This gyroscope receiver is used to control multicopters. Upgrading the receiver can also be used as a non-motorized system for mini helicopters up to 200 mm with a rear brush motor, a brushless rear motor or servo tail, or as a surface gyroscope for indoor models.
Motor and servo connectors are JST-SH connectors.
other functions
A very direct sense of control by eliminating another transmission path for flight control
Quick and easy assignment of gyroscopes
SUMD output for external devices
Telemetry support for HoTT and third-party sensors
It can be fully programmed and controlled using previously available HoTT transmitters, so no notebook is needed
Specifications
Number of antennas: 1
Flight Length [mm]: 1 x 30
Operating voltage neutral [V]: (2,5) 3,6 ... 8,4
Width [mm] 27
Frequency: 2400 ... 2483.5
Total weight [g] 7
Height [mm] 12
Channels: 5
Overall Length [mm] 35
Modulation: 2.4 GHz FHSS
Range approx. [m] 300
Stabilization: surface, copper FC, Heli FBL
Current consumption [mA] 45
Temperature range [° C]: - 15 ... + 70 ° C
