Absima Micro Jimny 1:24 RTR yellow

Absima Micro Jimny 1:24 RTR yellow
Mini expedition model suitable not only for the office, living room, but also for the garden. Thanks to the permanently closed differentials , the model has a decent cross-country ability (obviously considering its size). The chassis is designed the same as the large 1:10 expedition specials, i.e. metal frame, plus solid axles suspended on a classic 4-link. The dampers are plastic without oil filling. Metal shock absorbers can be purchased as a tuning part, as well as wheel weights or metal cardans. Soft tires with great grip and an optimally designed pattern significantly help to overcome any obstacles. Both the steering and the throttle are fully proportional. The model lexan body with many accessories is equipped with LED lighting (front reflectors and rear taillights). The driving time is 30-50 minutes, it depends on the driving style and the surface on which you drive. Charging the drive battery with the included USB charger takes about 30 minutes.

Basic properties
- 1:24 scale
- 4WD (four wheel drive)
- Signal transmission in the 2.4 GHz band (can drive more than models at the same time)
- Large gear ratio 104:1
- DC electric motor 88T/030
- Fully enclosed differentials (front and rear)
- Telescopic drive shafts
- Metal main chassis frame
- Drag/Mountain Brake (brake in neutral)
- Digital proportional control for sensitive driving maneuvers
- LED lighting (front and back)
- Plastic rims with super soft M/T tires
- Waterproof mini servo steering
- 2 in 1 speed controller/receiver unit
- Driving time: approx. 30-50 minutes

TECHNICAL SPECIFICATIONS:

Controller/Receiver: 2in1 ESC/RX, PPX4, 10A/50A
Remote control: 2.4 GHz, 4 channels
Servo steering: pull 1kg, waterproof
Motor: 030/88T DC
Gear ratio: 104:1
Battery: LiPo 7.4V/2S 360mAh
Battery connector: Molex 2-Pin / for charging service, type XH
Wheelbase: 121 mm
Clearance: 25 mm
Length: 215 mm
Width: 104 mm
Height: 120 mm
Weight: 250 g
Wheels: 45x18mm

Package contains:
Assembled model, transmitter, drive battery, USB charger, wheel nut wrench, screwdriver, sticker set, manual


4xAAA batteries for the transmitter need to be purchased for operation.
A suitable adapter with a USB output is required to power the USB charger, you can use e.g. a charging adapter from your mobile phone/tablet or you can use a USB output from a PC or laptop, etc.