DJI - F450 SET quadcopter - used

More information about the original product:

Kit of quadrocopy mechanics for recreational and semi-professional flying in the splinter. After completing the RC (at least 6 channels) RC, 3S drive and Li-Po battery, you'll get an excellent platform for further multi-copy experiments - from simple flying for joy to aerospace or FPV flying.

The core of the model drag are two center composite boards that carry control electronics, a drive accumulator, and possible "payload". On the bottom plate, conductive paths are created to provide the power supply to individual controllers and reduce the number of cables on board - this is also a significant weight saving. The motors are supported on lattice arms molded from rigid glass-filled plastic with pressed brass bushings for bolts.

The entire assembly of the kite is very simple - it includes powering the regulator power cables to the bottom plate and screwing the center plates with the arms and motors with the supplied hexagon bolts - be sure to secure them with a suitable screw locking device - ZAP Z-42, blue Loctite,

The model drives the propulsion system E305 - quadrule C2312E / 800 rotary crankshaft motors, their speed is controlled by four 20 A opto-controlled 420LITE controllers - this allows the power to use the Li-po four-element. The kit includes two pairs of 9.4x5 "right-handed / left-handed propellers, which you use when feeding from a four-piece. <" / p>

As a control unit, we recommend using the DJI NAZA-M V2 autopilot for comfortable operation of all main functions (cloning, tilting, sideways, engine speed), remote tuning of the control electronics parameters, as well as control of auxiliary load functions such as the swinging hinge of the camera. The NAZA-M V2 is compatible with conventional 2.4GHz receivers, FM / PPM receivers, as well as S-BUS receivers. Allows the model to operate in three flight modes - manually operated, with automatic flight pattern stabilization and flying in GPS mode with automatic flight stabilization and geographic position / height of the model. Both intelligent fail-safe functions are available in case of loss or strong interference of the control signal; when the GPS autopilot is connected, the model moves to a height of 20 m, returns to the starting point (in a 10 m radius) and automatic landing.

When using an intelligent control unit such as the NAZA-M V2, the demands of the RC model control kit are quite small - for basic flying, a six-channel computer RC set (preferably 2.4GHz) is required, which should have at least one channel controlled by a three-position switch for switching flight modes. If you want to make full use of the NAZA-M V2 autopilot and the model itself, you should have at least a 7- or 8-channel transmitter. You use the aerobatics program to control the model (you only need basic functions such as adjusting the amount of deflection) so that less or more sophistication of the heli program of your transmitter does not play a role.

• Composite and plastic parts of the dragon
• 4 AC motors C2312E-800
• 4 ACO controllers 20A Opto 420LITE
• fasteners
• instructions

This product is provided with professional technical support, authorized warranty and post-warranty service, and includes a full Czech instruction manual. <" / h3>