GPS/Vario ALPHA module HoTT (replacement for 33600)

GPS sensor providing heading, speed, altitude, longitude and latitude, distance and trajectory information. Technical data: -500 m ... + 3000 m, resolution 0.1 m, varia sensitivity: 0.5 m/3 s, 1 m/3 s, 0.5 m/s, 1 m/1 s, 3 m/s for tone programs.

S8437

New product

Graupner/SJ

In stock: 3 pcs
Stores and delivery dates
Price with VAT:
(DPH CZ 21%)
109,52 €
Price without VAT
90,52 €

B B

More info

Recommended accessories

Recommended for models

More info

GPS sensor providing information on course, speed, altitude, latitude and longitude, distance and trajectory. The module uses ultra-fast sensors so it is also suitable for use in Alpha racing docks.

  • vario with altimeter signaling and signaling capability of 5 height points achieved when climbing / descending
  • other alert signals to reach maximum and minimum altitude and descent and pitch in two stages
  • display and store information about maximum and minimum altitudes
  • GPS information about distance, course, speed, altitude, latitude and longitude, trajectory
  • the time alert can be set to: OFF, 5, 10, 15, 20, 25, 30 sec, permanent warning
  • Repeated time alert can be set to: standing, 1, 2, 3, 4, 5 minutes, once
  • The GPS / Vario sensor can be connected directly to the telemetry input of the receiver (GR16, GR24, GR32). At the GR12 receiver, the module is connected to the channel output 5, which needs to be changed to telemetry.

In case you need to connect multiple modules, you can connect them to the receiver using the Y-cable.

Technical parameters:

  • Range of measured height: -500m - 3000m
  • Resolution: 0.1m
  • Sensitivity vari: 0.5m / 3s, 1m / 3s, 0.5m / 1s, 1m / 1s, 1.3m / 1s
  • Averaging: 4 - 40 measurements per programmable measured values
  • Power consumption GPS + Vario: approx. 110 mA
  • Dimensions: 38x45x16mm

Important notice when using telemetric modules 33600, 33601, 33610, 33611 and 33620:
  • Never make any adjustments or adjustments during the model flight so that the model does not get out of control due to your inattention.
  • In any case, do not perform the telemetry modeling and programming in flight if your model is equipped with two receivers. Program changes can affect the receiver without switched telemetry modules and this may cause loss of control over the model. <" / li>

Always perform all programming and setup on the ground and make sure that only the receiver with active telemetry units is powered.
"

Recommended accessories

Recommended for models