Airplane flight module for 2-14S Gr. HoTT with Vario and XT90 connectors

The main telemetry receiver module for Graupner Hott and modelys motor.

• Vario with altitude signaling and signaling the possibility of lifting 5 points achieved during ascent / descent
• display height (-500 ~ +3000 m) and storing information on the maximum and minimum height
• 2x temperature and voltage sensor inputs. Warning thresholds for minimum / maximum voltage and minimum / maximum temperature
• measuring the voltage of each cell (balance connector) system to achieve the minimum voltage for 2-14s Lithium aakumulátorů
• measuring voltage, current and capacity warning reached the minimum / maximum voltage, maximum capacity and maximum current
• programmable current limit
• Current measurement using shunt 2x 1 mOhm parallel = 0.5 mOhm
• measuring the speed with warnings reaching the min / max values
• measurement of fuel level warning in increments of 25%
• Asa warning can be set to: OFF, 5, 10, 15, 20, 25, 30 seconds, a permanent warning
• repeated time alert may be set to: a constant, 1, 2, 3, 4, 5 minutes, once

Important notice when using telemetry modules 33600, 33601, 33610, 33611 and 33620:

• Never make any software modifications or adjustments during the flight model to model not get out of control because of your carelessness.
• In any case neporvádějetě up and programming model telemetry during the flight, if your model is equipped with two receivers. Program changes may affect the receiver without reconnected telemtrických modules and thus may lose control of the model.
• All programming and setup Always on the ground and make sure that the power is the only receiver with active telemetry units.