1HI29935
New product
Availability date:
Fuel level sensor signals the pilot 5 fuel levels in the tank (full, 3/4, 1/2, 1/4 and empty). The sensor provides data even during inverted flight; It is designed only for use in models with glow plug (methylakoholové fuel).
Installation is very simple. Sensors simply stick on the outside of the tank, connect the scanner to fix the double-sided tape to the appropriate part of the model, plug the cable into the sensor telemetry data logger and you go flying. For an especially easy mounting sensor is composed of a flexible printed circuit provided with a self-adhesive layer (covered with protective film) on both sides and connectors are doubled - short and long side of the sensor.
Warning - Turn on the system before natankováním tank, otherwise it would have been incorrectly auto-calibration sensor when you turn.
During extreme 3D flying may be inaccurate sensor data. If this happens, try for a few seconds depend (in a helicopter), or go into a horizontal flight (aircraft) to once again get the correct information.
Sensor Kit includes: fuel level sensor with cable, double-sided foam adhesive tape, 3 sensors (40x25 mm, 52x25 mm and 62,5x25 mm).
Tip: When connecting sensors to the sensor connector follow these steps: Hold the sensor so you can see the inscription "HTS-FUEL", nails thumb and forefinger, gently pull the beige fuse connector. To "unlocked" Carefully insert the connector plug on a flexible printed circuit board sensor so you can see gold items for each contact. Gently push the stop (about 5 mm) and secure it by inserting fuses sensor connector. If you plug the sensor in the wrong direction, it will not have contact and the device will not work.
Measuring range | Full, 3/4, 1/2, 1/4, Empty |
Cable length sensors | 250 mm |
Dimensions (sensor) | 40x17x5 mm |
Dimensions (sensor) | 40x25 mm, 52x25 mm and 62,5x25 mm, thickness 0.4 mm |
Weight (sensor + sensor) | 5 g |