5832 HTS-SS Telemetry Center Nitro

Telemetry data logger used to collect data from external sensors (up to 8 sensors) and jejj transmission to the telemetry receiver Hitec with data input (at the moment Optima Optima 7 and 9). As the name implies, "Nitro" is optimized especially for models powered by an internal combustion engine - airplanes, helicopters, cars and boats. The panel contains electronics "serving" the individual sensors - is therefore not possible to connect the sensor itself directly to the receiver, but always only through the exchange.

For proper operation, it is necessary to check in advance (and where necessary update using HPP-22) that:

• Aurora 9 transmitter software (if applicable) is version 1.07 or later
• Spectra software transmitter module 24 (or VF part in Optic 6 Sport 2.4GHz) is version 2.0 or later
• Optima software receivers (7 or 9) is version 2.0 or later

Instructions on how to perform the update can be found HERE .

The panel does not require any adjustment, involves using a pair of cables supplied with it - twisted triplex with a cable leading to a telemetry receiver input DATA, a flat cable is used to power the control panel and sensors (4,8-8,4V). You can connect it directly into an unused servovýstupu receiver. If they are all occupied, then using a Y-cable, or you can bring power directly from the battery switch receiver.

In addition to the data output (DATA) and an AC outlet (P) data logger has eight outlets with nezáměnnými connectors for different types of sensing sensors:

• R1, R2 - for connection speed sensors
• F - for connecting the fuel sensor
• G - for connecting GPS sensors
• T1, T2, T3, T4 - connection of temperature sensors

You can connect up to two speed sensor, no matter whether magnetic or optical socket number gives the address at which the sensor will appear on the transmitter display Aurora 9, or on a computer monitor when connected via HPP-22 to the transmitter module. < / P>

Similarly, you can connect up to four temperature sensors, bay number again indicates the address of the sensor.

Set telemetry control panel includes: a telemetry logger HTS-SS Nitro, power cable, data cable and a double-sided adhesive foam tape.