3BD1010
New product
This product is no longer in stock
Availability date:
The DC motors of the FOXY Brushed series are perfectly suited for a whole range of modeling applications - for the propulsion of aircraft, ships, cars, tanks and other ground-based and direct-to-gear ground technology.
When installing and connecting FOXY Brushed motors, make sure that you do not exceed the permissible values for supply voltage and current load.
Engine cooling: In operation, the temperature of the outer casing of the engine should not exceed 80 ° C. In the model, therefore, it is always necessary to ensure sufficient access of cooling air and its flow around the engine; in the case of ship models, we recommend using water cooling. High motor loads are only possible for short periods. After each flight / ride, the engine must be allowed to cool to room temperature before taking off / sailing again.
FOXY 280 7.2 V is a DC electric motor of size "280" with a shaft with a diameter of 2.0 mm and plain bearings suitable for driving indoor models of aircraft and parkflyers with direct drive (propellers 4.7x2.3 ", 4x3") or with a gearbox , for small car and boat models.
To control its speed, you will need an electronic controller with a load capacity of 8-12 A.
FOXY 250 7.2 V is a suitable replacement for the SPEED 280 7.2 V motor (cat. No. 7301).
Engine kit includes:Voltage (rated) [V] | 7.2 |
Voltage (operating) [V] | 3.7 - 7.4 |
Speed at rated voltage [rpm] | 15500 |
Regulator [A] | 8 - 12 |
Diameter [mm] | 23.8 |
Length (cabinets) [mm] | 30.5 |
Shaft diameter [mm] | 2 |
Free shaft length [mm] | 12 |
Weight [g] | 42 |