4ST17604
New product
Availability date:
Top-of-the-line EPP foam model for extreme 3D acrobatics in the lobby and outdoors. Now you can also experience a good dose of adrenaline with a top machine, designed, built and fought by the multiple champion of the Czech Republic in categories F3M, F3P and F6B Marek Plichta!
The model is now a classical design of printed EPP plate with a number of carbon fiber bumper stiffeners and struts made of carbon bars delivering the unit the necessary stiffness and durability. The chassis is made of carbon bars with foam wheels and covers. Dimensional rudders and auxiliary aerodynamic surfaces guarantee incredible dexterity and allow you to safely perform even the wildest 3D turns.
For the drive, you need an AXI 2203-2204 AC electric motor with a 10-12 A Race powered by a 2S LiPo battery with a 300-400 mAh battery. The controller should have the lowest weight, but the maximum load capacity of the BEC power stabilizer so that the servo does not restrict itself in frequent sharp movements.
A minimum of four-channel RC sets will be used to control the model, for 4-5 g servos (HS-5035MG), a 10-12 g servo (HS-5065MG) for ailerons to control the rudder and elevator.
Kit contains: Cut and printed parts of hull, wings and tail surfaces of EPP, carbon bars and flanges, small accessories, building instructions.
The model was designed and manufactured in the Czech Republic.
Span [mm] | 850 |
Length [mm] | 950 |
Weight [g] | 180-210 |
Controlled functions | S, V, K, M |
Construction demand | S1 |
Flight challenge | P2 |
Recommended drive and RC equipment:
GP | |
Engine | AXI 2204 / Race |
Regulator | Skywalker 12AE or FLYFUN 12AE |
Power accumulator | G3 RAY 7.4 V 350mAh |
Propeller | GWS 8x3,5 " |
Servos | 2x HS-5035MG, 1x HS-5065MG |
RC set | Min." 4 channels |