1-00887 Challenger Indoor Edition stavebnice

The family of MULTIPLEX hall models is starting to grow nicely! The high-performance 3D Flatbed EPP Challenger binoculars Challenger designed for AXI 2204/54 AC motors will surely delight every hall pilot.

Plate wings, hull and tail surfaces have slots for bonding carbon flanges; The stiffness of the whole model delivers sophisticated carbon fiber bars of 0.8 to 1.5 mm in diameter. The chassis has carbon foot legs and EPP plate covers and wheels. The motor motor bed is used to fasten the engine. For servos of ailerons, rudders and elevators you will find prepared cutouts in the hull; the rods of the carbon bars are used to control the rudders. The rudder and elevator shafts are guided by a number of guiding meshes to prevent their folding.

To drive the model, you need an AXI 2204/54 AC motor with a propeller propeller, a 12-15A controller, a 400-500 mAh two-cell LiPo battery, and a matching propeller. Multiplex also supplies a special drive kit that includes the ROXXY C27-15-1050kv AC motor and the ROXXY BL-Control 715 BEC controller.

For aileron control, we recommend using a HS-65HB servo with sturdy carbon gears or the like; HS-40 servos are suitable for rudder and elevator.

Two to three hours with a second glue and UHU-POR in hand is enough to complete this special able to hang on the propeller and perform all the other 3D pieces! It is also designed for less experienced pilots; with less deflections, anyone with at least some acrobatic practice can fly with it and is able to reliably fly with the previous model loop, head and roll. Due to the low weight of a crash model due to "hand entanglement" it does not hurt too - and the repairs are so easy!

The kit includes: Hull, wings, tail and chassis cover from printed EPP, plastic engine bed, carbon reinforcements and other small accessories, EPP light carbon chassis and construction instructions <" / p>