Alpha 1000mm RTR brushless red

Large 1060 mm plastic power-hung motor barge for deep adrenaline driving on larger water bodies at speeds up to over 80 km / h!

The model is delivered ready-to-go (just fit the rudder and the bolt, store your receiver in the supplied water balloon, charge and insert the battery packs) with the high performance BL4260 and 90A Hobbywing water cooling controller. Cooling water is sucked by a nozzle in the rudder, out of the boat is drawn from the right side. Engine power is transmitted by a direct clutch to a flexible ship shaft mounted in a teflon housing (adjustable inclination) with a half-mounted two-piece metal screw. The model ships two screw sizes - smaller (56 m) is designed to power the 6S battery; larger (60 mm) for 4S battery. Direction of travel is controlled by a rudder made of CNC machined duralumin parts.

The model features a range of adjustable features to fine-tune driving performance - you can adjust the angle of inclination of the shaft with the ship's bolt, trim flaps for optimal positioning of the fuselage against the water level, and an auxiliary fin which influences cornering behavior.

The onboard electronics include a water-cooled Hobbywing SeaKing 90A V3 RTR electronic speed controller and a strong (9 kg.cm) standard servo rudder.

Access to the engine, batteries and electronics provides a removable cover; which is wrapped around the perimeter with a self-adhesive tape to ensure perfect watertightness.

To power the model, you will need two two-cell or two three-cell Li-po batteries of 5000 mAh with a load of at least 35C. Batteries are connected in series - with a pair of twin cells, the maximum speed of the model is about 60 km / h, with two three-strokes it is up to 80 km / h. < / p>

The RTR set includes: a ready-made RC model, a rudder set, a 56 and 60 mm screw bolt, a wooden stand, alveolar levers, a rubber balloon, and a manual.

Recommended drive and RC equipment: