Multifunction LCD programming box

Multifunctional programming LCD box for HobbyWing AC ESC controllers

HW30502000

New product

HOBBYWING

Sale ended

More info

More info

Multifunction LCD programming box for regulators selected series Hobbywing for cars, airplanes and boats are used for easy and fast programming of controllers - at home "on the table" as well as at the airport, on the racetrack or on the water. In addition, it can serve as a USB interface for connecting the controller to a PC for programming it using the USB Link and firmware update. It is also equipped with a connection which enables to measure the total voltage and voltage of each cell rechargeable LiPo 2-8S sets.

1. APPLICATION FOR PROGRAMMING THE CONTROLLER

The controller is connected via servocable or special programming cable socket located on the left side of the box. Power box is provided from BEC power stabilizer Hobbywing controller or current 4-5čl. NiCd / NiMH or 2S LiPo / LiFe battery pack attached to the receiver box (if the regulator OPTO). Programming is done with the attached drive motor and battery (even if OPTO controllers).

Hobbywing air regulators can be programmed in a model fitted with a propeller - for safety reasons, but it is recommended to remove the propeller programming - To prevent possible accidents at some omission or operator error. Likewise Perform programming controllers in cars and ships safely seated on a stand with wheels, respectively. the propeller in the air or the removed pinion or clutch ship shafts.

For programming, the four buttons on the front panel of the box. With their help you select the program functions ( "ITEM") for adjusting and setting the value ( "value"). Press "R / P" is selected programmed profiles stored in the memory box, click "OK" to confirm the change made and sent to the controller. Name of program functions and its value are displayed on dual line LCD display. < / P>

The connection method controller for multifunction LCD programming box depends on the type of regulator - differs according to whether it is a controller with BEC stabilizer power or OPTO controller whether the controller has special programming cable or socket etc. When connecting proceed exactly according to the instructions supplied with the box and your controller.

2. use USB interface for connecting the controller to the PC

After connecting the controller with LCD programming box connects to the PC via USB cable. After running the program USB Link, you can easily adjust the controller to PC or PC to update the firmware.

3. USE as a voltmeter to control the voltage LIPO BATTERY

Service connector set of plug in "BATTERY CHECK" on the right side of the box; The display then shows the voltage across a set of individual cells. (When measuring voltage LCD programming box powered from measured service connector kit does not need another source.)

Compatible regulators Hobbywing

  • Platinum for model airplanes and helicopters
  • XERUN and EZRUN for car models
  • Seaking PRO for model boats
[V] 4.5 to 12.6
Length [mm] 90
Width [mm] 51
Height [mm] 17
Weight [g] 65