RAY programming card for R-12 / 70A BEC

Programming card for air controllers RAY serve for easy and fast programming controllers - at home "on the table" or even at the airport. Programming card can also be used for setting up regulators in ARF and RTF models from EPP Pelikan Daniel FOX 2300, ASK-23 (2300 mm), ASW-28 (2300 mm), Cessna 182 (1400 mm), Cessna 400 (1400 mm) Piper J-3 Cub (1400 mm), the EPP models of fighters and bombers firm FMS series Warbird Series (1400 mm) and Baby Warbirds (750-800 mm), the model MULTIPLEX Extra 300 models Tech-One Lazy Flyer Trainer King and many others.

The controller is connected via servocable socket is located at the top of the card. The card's power is provided from BEC power stabilizer regulator RAY or ordinary 4-5čl. NiCd or NiMH receiver battery pack attached to the card (if the regulator OPTO). Programming is done with the attached motor drive and battery (even if OPTO controllers).

RAY controllers can be programmed in a model with a mounted propeller - for security reasons, but still recommended to remove the propeller programming - To prevent possible accidents at any omissions or operator error.

For programming, the jumper pushing for contacts around the perimeter of the card. First, put all jumpers in position to select the desired values. Then, connect the card to the controller and connect the drive battery. The controller will beep to save the set parameters; Disconnect the drive battery and card - that's it, you can start!

List of features and possible values \u200b\u200bcan be found on a label on the card, a detailed description of the functions indicated in the instructions supplied with regulators RAY.