BH152 FOX glider 6000mm ARF

Polish two-seat aerobatic glider MDM-1 made an excellent impression on entry into the international scene in 1993 - the world championship aerobatic gliders with him Jerzy Makula won smoothly. And in collecting medals on the Polish national team he continued in the next two decades.

ŠestimetrovýFOX from the production of Black Horse designed especially for aero-tow and thermal flying. Its design also allows for the installation of engines brushless motor AXI 5345-5360 performance class with a folding propeller in the bow model.

The fuselage consists of lightweight plywood partitions with solid celobalsovým coating coated iron-on transfers Oracover. For easier transport JZE fuselage split in two halves joined duralumin tubes and screws; parting plane runs behind the trailing edge of the wing. Access to the on-board electronics provides a removable canopy - under the clear "bubble" to find the dummy pilot dashboard and the concentrated expression of an experienced aerobatic pilot. The bow is ready sliding plywood bed for mounting the electric motor in the rear mounting.

The four piece wing is pushed to the side of the coupling consisting of two robust dural tube is a classic design with torsion box with balsa solid coating and coated iron sheets Oracover. The outer part of the wings are removable, to connect the two dural tube connector and ensure the screws. The ailerons are divided into two parts (inner and outer panel of each wing) and are ruled by two servos with short straight rods.

Empennage in conventional arrangement are balsa, balsa horizontal stabilizer has a coating; The tail is again coated Oracover. For ease of transportation the horizontal and vertical tail removable, fastened with screws. Halves of the elevator are controlled through short wire rods strong standard size servos mounted horizontal stabilizer. Rudder is controlled by servo placed in kýlovce.

Landing gear consists of one unsprung around half protruding from the contour of the trunk and spurs.

To control the model you need six powerful servos standard size with a thrust of about 10 kg.cm for rudder 15-20 kg.cm.

RC kit should be computed at least 9 channels.

Motorization model FOX can power an engine mounted in the front fuselage folding propeller on bare stringer without cone - such a solution is almost invisible, whether the engine is running or not. Ensure sufficient power brushless motor AXI 5345 class with dvanáctičlánkovým LiPo battery.

Kit includes: structural fuselage, wing and tail surfaces coated Oracover, accessory kit, instructions.

RC glider recommended equipment:

Recommended RC equipment Elektra: