RACE COPTER ALPHA 250Q RACE FPV

FPV Race with small quadrocopters is becoming more and more popular, and flying between obstacles becomes an adrenaline entertainment of an increasing number of modellers. Racing tracks constructed from artificial obstacles or pathways created by natural obstacles attract an increasing number of "enthusiasts" and this category is experiencing its great rise.
Nor is Graupner behind, and the new Race Copter Alpha 250Q specially developed specifically for flying with video or FPV monitors comes to market. Experience this true adrenaline and enter the world of FPV Race.

The Alpha 250Q is made entirely of carbon materials that deliver the necessary stiffness, durability and extremely low weight. The double hull allows safe installation of the speed controllers, while allowing the model to be properly "erased" - no cables extending along the shoulders.

The model is supplied complete with installed motors, regulators, receiver with control unit, voltage sensor and front and rear LEDs.

The model is equipped with 4 2804/2300 AC motors delivering the model along with four 12A AC controls, extreme agility and high speed.
For fast flying between obstacles, it is necessary to use a quality control unit that will ensure the model is highly dexterous while maintaining high stability. All these features are completely met by the control unit integrated into the GR-18 HoTT receiver, thus avoiding the need to use the control unit separately and the receiver separately. The gyroscope receiver is set up using either a transmitter or Smart Box. The control unit operates in two flight modes - starting for pilots and fully manual racing mode. At the same time, the model is equipped with a voltage module to ensure that the pilot always has an overview of the state of the battery.
For better "readability" of the model in the air, the quadrocopter is equipped with a red LED strip on the back and a white LED stripe on the bow. <" / p>

To control the model, use min. 6-channel RC kit (MX-12, MZ-12 and above.
A Li-Pol battery of 3s (11.1V) with a capacity of 1200-1600 mAh is recommended for the drive.

Properties:

• Very high stability
• The design allows only damaged parts to be changed in a crash
• Highest quality used carbon material and anodized aluminum parts
• Extremely accurate controllability of the model
• Double frame design featuring secure electronics storage
• Versatile design to use two cameras
• Variable design for easy repairs
• Speed \u200b\u200bover 100km / h (with Li-Pol accu 3s)

Kit content:

• completely assembled model
• 4x AC motor 2804/2300
• 4x AC controller 12A
• 4x propeller (CCW + CW
• before the GR-18 Gyroscope Receiver is programmed
• LED strip red
• LED white belt
• Voltage Module
• FPV camera 1/3 SONY CCD-600TVL
• 25mW 5.8GHz video transmitter
• FAT SHARK Attitude glasses