RACE COPTER ALPHA 250Q RACE FPV camera

FPV Race with small quadcopter is becoming increasingly popular among obstacles and flying is becoming increasingly adrenaline fun group of modelers. Race tracks built from artificial obstacles or paths formed by natural barriers that attract a growing number of "fans" and this category is experiencing its great rise.
Neither company Graupner not far behind and the market comes a new, purely racing special Race copter Alpha 250Q, which was developed mainly for flying with videobrýlemi or FPV monitor. Experience with this model a real adrenaline rush and enter the world of FPV Race.

Alpha 250Q is made exclusively of carbon materials, which give the necessary rigidity resistance and extremely low weight. Double hull allows for secure installation of speed controllers and also gives the opportunity to have the model properly "pimped up" - no cables running along the shoulders.

The model is supplied completely assembled with installed motors, controllers, receiver with controller, voltage sensor, and front and rear LEDs.

The model is equipped with 4 AC motors supplying the 2804/2300 model, along with four alternate controllers 12A extreme maneuverability and high speed.
For fast flying between obstacles, it is necessary to use a quality control unit that ensures high mobility model while maintaining high stability. All these features perfectly meets the control unit is integrated into the receiver GR-18 Hotta, eliminating the need to use a separate control unit and a separate receiver. Setting gyroscopic receivers is performed by the transmitter or by using Smart Box. The control unit operates two flight modes - mode for beginner pilots and racing full manual mode. At the same time, the model is equipped with a voltage module, which ensures that the driver always has an overview of the status of the drive battery.
For better "readability" of the model in the air quadcopter is equipped with a red LED strip on the back of a white LED strip at the bow. < / P>

To control the model you need to use min. 6-channel radio system (MX-12, MH-12 and above.
To drive is recommended for Li-Pol battery 3s (11.1V) with a capacity of 1200 to 1600 mAh.

Properties:

• Very high stability
• Construction for the accident only change damaged parts
• Highest quality of the carbon material and anodized aluminum parts
• Extremely precise controllability model
• The double frame design offering secure storage of electronics
• Universal design enables the use of two cameras
• Flexible design allows easy repair
• The speed of over 100 km / h (Li-Polymer accu 3s)

Contents of the kit:

• completely assembled model
• 4x brushless motor 2804/2300
• 4x brushless controller 12A
• 4x propeller (CCW + CW)
• Before programming Gyro Receiver GR-18
• LED red tape
• LED strip white
• voltage module
• FPV Camera 1/3 SONY CCD-600TVL
• 5,8GHz 25mW video transmitter