OPTIMA 9 2.4GHz receiver AFHSS 9 channels dual antenna

Devítikanálový 2.4 GHz receiver with Hitec AFHSS system with telemetry transmission, full-range and higher supply voltage range (4-5 Ni-xx, 2s Li-poly). Determine the receiver is for general use in normal and large models of all categories; thanks to its small size, low weight and connectors zasouvaným longitudinal axis is suitable for models with a slender fuselage. Using AFHSS transmission technology provides high noise immunity and the ability to set the emergency deflections (fail-safe) in case of failure or strong interference signal transmitter. OPTIMA 9 2.4GHz circuitry includes two receivers with special antennas that operate in parallel, which ensures correct installation of antennas (mutually perpendicular) to the high reliability of transmission control signal regardless of the relative position of the transmitter and the model. In this way it is possible to minimize the influence of directivity receiver antennas to achieve hitherto unknown levels of security transfer control signal for large and fast models of airplanes and helicopters.

Pairing with a transmitter and setting the fail-safe emergency deflections is carried out via the programming SET button on the receiver operating states are indicated by 2 LEDs.

Telemetry: The receiver is equipped with a data socket ( "DATA") to connect telemetry exchanges telemetry for transmission to the transmitter. The control panel allows you to connect up to 8 sensors. Without additional sensors receiver to the transmitter transmits data about the supply voltage of the receiver.

SPC system: In addition to the normal supply of Article 4-5. NiCd / NiMH or 2s lithium battery (Li-poly, Li-Fe, Li-ion) receiver can be powered via built-in stabilizer power. In this case the supply voltage (V 4,8-35) fed on SPC outlet from which is taken jumper with which the receiver is supplied. SPC system provides power only receiver to power servos need for any of the drawers Channel 1 .. .9 Bring supply voltage 4.8 to 7.4 V (depending on the type of servo voltage greater than 6.0 V for servos series HV) V. Thanks to the SPC as you can with electro receiver is powered directly from the drive battery and bypass the risk of outages voltage or total failure of BEC power stabilizer in the speed controller. For large models combustion engine in turn can be used for simple SPC creating a dual supply system with a separate battery for the receiver and other servo without the need for further additional circuits or equipment.

When using a PC interface HPP-22 utility (free to download on the website of RCM Pelikan and Hitec) you can update the receiver's software.

OPTIMA 9 2.4GHz receiver is equipped with jacks for standard connectors UNI (= JR / Graupner, Hitec, Futaba).