55818 RX-7 M-LINK 2.4 GHz receiver

Miniature seven-channel receiver 2.4GHz M-LINK, Fail-safe, telemetry, PC interface, two-receiver operation or serial servo output SRXL-MULTIPLEX, power supply 3.5 ... 9.0V. Weight 13g. Full range, reduced box.

1M151490-1

New product

Multiplex

Sale ended

More info

More info

Miniature sedmikanálový 2.4 GHz FHSS receiver system MULTIPLEX M-LINK transmission of telemetry and increased supply voltage range (4-6 Ni-xx, 2s Li-poly). Using M-LINK transmission technology provides high noise immunity and the ability to set the emergency deflections (fail-safe) in case of failure or strong interference signal transmitter.

Determine the receiver is for general use, especially in smaller and lighter models of all categories; its compact size, low weight and connectors zasouvaným longitudinal axis is particularly suitable for models with a slender fuselage, such as RC hand launch gliders like.

RX-7 M-LINK is possible by means of diversity # 85070 cable to connect to the "tandem" with any M-LINK MULTIPLEX receiver allowing "dvoupřijímačový" operating mode. Then connect the receiver to the board model working together, the servos are always transmitted signal from the receiver with the best quality reception. They simply can realize on-board system with dual or triple diversity (if a second receiver from a range of double "DR") for providing ideal reception conditions, thereby eliminating the influence of directivity of the receiver antennas. You will enjoy a hitherto unknown level of security transfer control signal.

RX-7 M-LINK also has the option to output servo signals transmitted to other devices, such as control units for Flybarless helicopter or multikoptéry in serial form via a single cable system SRXL-MULTIPLEX. This greatly simplifies board installation, eliminating the number of connecting cables. Note .: The receiver can operate in either mode dvoupřijímačovém or serial servo output - both at the same time is not possible.

Pairing with a transmitter and setting the fail-safe emergency deflections is carried out via the programming SET button on the receiver operating states are indicated by LEDs.

The receiver is equipped with a data socket for connecting external sensor modules (up to 16 modules interconnected in series) telemetry for transmission to the transmitter. < / P>

When using a PC connection cable and PC # 85149 MULTIPLEX Launcher program (free download at the website MULTIPLEX) or Programmer # 82094 MULTImate can adjust emergency deflection Fail-safe individually for each channel. It can enable the combined settings common for helicopter models - in case of emergency, the gas down on idle while the other servos maintain the last correct position, thereby reducing the risk of sudden "jump" collective and cyclic control after the restoration of normal income.

When using a PC connection cable # 85149 and PC program MULTIPLEX Launcher can also update the receiver's software, examine in detail the counter error conditions (which detects a power failure and reception) and assign addresses for external telemetry sensor modules (being one of the addresses can be set as a priority - the value of it will be to the transmitter wander more often than other sensors, so that the selected value will be fresher, without delay) and switch dvoupřijímačový operating mode or operation with serial servo output.

Receiver RX-7 M-LINK is equipped with jacks for standard connectors UNI (= JR / Graupner, Hitec).

Allows connection stabilization system MULTIPLEX WINGSTABI.

Modulation / Coding 2.4GHz M-LINK
Number of channels 7
Function Fail-safe, Telemetry, Dvoupřijímačový operation
power 4.8V, 6V, 7.4V
Length [mm] 54
Width [mm] 22.3
Height [mm] 11.5
Weight [g] 13